Welcome to Retro Commodore Q&A, where you can ask questions and receive answers from other members of the community.

How do I connect the USB-Seriel cable to the GOTEK drive

0 votes
There are 4 wires on the USB cable, how are these connected to the GOTEK drive?
asked Nov 15, 2015 in Amiga by Tomse C64 (100 points)

1 Answer

0 votes

As on the pic below.
Red goes to the 5v on the power connector.
Black goes to GND on the power connector.
White goes to TX.
Green goes to RX.
Boot0 is jumpered to 3.3v (set to high).

If the Flash-Demo software says unrecognized, short the reset for a sec, and then try again.

More info here:

https://cortexamigafloppydrive.wordpress.com/


answered Nov 15, 2015 by Tomse C64 (100 points)
...